$A$ galvanometer has a coil of resistance $100 \, \Omega$ and gives a full-scale deflection for $30 \, mA$ current. If it is to work as a voltmeter of $30 \, V$ range,the resistance required to be added will be..... $\Omega$

The range of a voltmeter of resistance $G \ \Omega$ is $V$ volt. The resistance required to be connected in series with it in order to convert it into a voltmeter of range $nV$ volt, will be

The deflection in a moving coil galvanometer falls from $50$ divisions to $10$ divisions,when a shunt of $12 \Omega$ is connected with it. The resistance of the galvanometer coil is . . . . . . . (in $\Omega$)

To find the resistance of a galvanometer by the half-deflection method,the experimental data obtained are given in the table below:

$S. No.$	Resistance $R \ (\Omega)$	Deflection $(\theta)$	Shunt $S \ (\Omega)$	Half deflection $(\theta / 2)$	Galvanometer resistance $(G)$
$1$	$3300$	$30$	$80$	$15$	$G_1$
$2$	$5000$	$20$	$80$	$10$	$G_2$

From the above data,the galvanometer resistance $G$ will be near to: (in $\Omega$)

$A$ galvanometer is used in a laboratory for detecting the null point in electrical experiments. If, on passing a current of $6 \ mA$, it produces a deflection of $2^{\circ}$, its figure of merit is close to (each division is $1^{\circ}$):

$A$ student is provided with a variable voltage source $V$,a test resistor $R_T=10\,\Omega$,two identical galvanometers $G_1$ and $G_2$,and two additional resistors,$R_1=10\,M\,\Omega$ and $R_2=0.001\,\Omega$. For conducting an experiment to verify Ohm's law,the most suitable circuit is: