$A$ projectile of mass $3m$ explodes at the highest point of its path. It breaks into three equal parts. One part retraces its path,the second one comes to rest. The distance of the third part from the point of projection when it finally lands on the ground is ........$m.$ (The range of the projectile was $100\,m$ if no explosion would have taken place.)

$A$ thin hollow cylinder slides with velocity $v$ without rotating. It then rolls without slipping with the same velocity $v$. Find the ratio of the kinetic energies in the two cases.

$A$ uniform disc is rolling on a horizontal surface. At a certain instant,$B$ is the point of contact and $A$ is the topmost point of the disc,where $R$ is the radius of the disc.

The general motion of a rigid body can be considered to be a combination of $(i)$ a motion of the centre of mass about an axis,and $(ii)$ its motion about an instantaneous axis passing through the centre of mass. These axes need not be stationary. Consider,for example,a thin uniform disc welded (rigidly fixed) horizontally at its rim to a massless stick,as shown in the figure. When the disc-stick system is rotated about the origin on a horizontal frictionless plane with angular speed $\omega$,the motion at any instant can be taken as a combination of $(i)$ a rotation of the centre of mass of the disc about the $z$-axis,and $(ii)$ a rotation of the disc about an instantaneous vertical axis passing through its centre of mass (as is seen from the changed orientation of points $P$ and $Q$). Both the motions have the same angular speed $\omega$ in this case. Now consider two similar systems as shown in the figure: Case $(a)$ the disc with its face vertical and parallel to the $x-z$ plane; Case $(b)$ the disc with its face making an angle of $45^{\circ}$ with the $x-y$ plane,its horizontal diameter parallel to the $x$-axis. In both the cases,the disc is welded at point $P$,and systems are rotated with constant angular speed $\omega$ about the $z$-axis.
$1.$ Which of the following statements regarding the angular speed about the instantaneous axis (passing through the centre of mass) is correct?
$(A)$ It is $\sqrt{2} \omega$ for both the cases.
$(B)$ It is $\omega$ for case $(a)$; and $\frac{\omega}{\sqrt{2}}$ for case $(b)$.
$(C)$ It is $\omega$ for case $(a)$; and $\sqrt{2} \omega$ for case $(b)$.
$(D)$ It is $\omega$ for both the cases.
$2.$ Which of the following statements about the instantaneous axis (passing through the centre of mass) is correct?
$(A)$ It is vertical for both the cases $(a)$ and $(b)$.
$(B)$ It is vertical for case $(a)$; and is at $45^{\circ}$ to the $x-z$ plane and lies in the plane of the disc for case $(b)$.
$(C)$ It is horizontal for case $(a)$; and is at $45^{\circ}$ to the $x-z$ plane and is normal to the plane of the disc for case $(b)$.
$(D)$ It is vertical for case $(a)$; and is at $45^{\circ}$ to the $x-z$ plane and is normal to the plane of the disc for case $(b)$.
Give the answer for question $1$ and $2$.

$A$ hoop of radius $r$ and mass $m$ rotating with an angular velocity $\omega_0$ is placed on a rough horizontal surface. The initial velocity of the centre of the hoop is zero. What will be the velocity of the centre of the hoop when it ceases to slip?

$A$ meter stick is held vertically with one end on the floor and is allowed to fall. The speed of the other end when it hits the floor,assuming that the end at the floor does not slip,is ......... $m/s$ $(g = 9.8 \, m/s^2)$.