$A$ long solenoid with $2000$ turns per meter has a small loop of radius $3 \,cm$ placed inside the solenoid normal to its axis. If the current through the solenoid increases steadily from $1.5 \,A$ to $5.5 \,A$ in $\frac{\pi^2}{100} \,s$, the induced emf in the loop is (in $\,mV$)

$A$ square loop $PQRS$ having $10$ turns, area $3.6 \times 10^{-3} \, m^2$ and resistance $100 \, \Omega$ is slowly and uniformly being pulled out of a uniform magnetic field of magnitude $B=0.5 \, T$ as shown. Work done in pulling the loop out of the field in $1.0 \, s$ is . . . . . $\times 10^{-6} \, J$.

$A$ square loop of area $25 \, cm^2$ has a resistance of $10 \, \Omega$. The loop is placed in a uniform magnetic field of magnitude $40 \, T$. The plane of the loop is perpendicular to the magnetic field. The work done in pulling the loop out of the magnetic field slowly and uniformly in $1 \, s$ will be:

$A$ metallic cube of side $15\,cm$ is moving along the $y$-axis at a uniform velocity of $2\,m/s$ in a region of uniform magnetic field of magnitude $0.5\,T$ directed along the $z$-axis. In equilibrium,the potential difference between the faces of higher and lower potential developed because of the motion through the field will be $..........mV$.

$A$ long straight wire carries a current,$I = 2 \text{ A}$. $A$ semi-circular conducting rod is placed beside it on two conducting parallel rails of negligible resistance. Both the rails are parallel to the wire. The wire,the rod,and the rails lie in the same horizontal plane,as shown in the figure. Two ends of the semi-circular rod are at distances $1 \text{ cm}$ and $4 \text{ cm}$ from the wire. At time $t = 0$,the rod starts moving on the rails with a speed $v = 3.0 \text{ m/s}$. $A$ resistor $R = 1.4 \text{ } \Omega$ and a capacitor $C_0 = 5.0 \text{ } \mu\text{F}$ are connected in series between the rails. At time $t = 0$,$C_0$ is uncharged. Which of the following statement$(s)$ is(are) correct? $\left[\mu_0 = 4\pi \times 10^{-7} \text{ SI units}, \ln 2 = 0.7\right]$
$(A)$ Maximum current through $R$ is $1.2 \times 10^{-6} \text{ A}$
$(B)$ Maximum current through $R$ is $3.8 \times 10^{-6} \text{ A}$
$(C)$ Maximum charge on capacitor $C_0$ is $8.4 \times 10^{-12} \text{ C}$
$(D)$ Maximum charge on capacitor $C_0$ is $2.4 \times 10^{-12} \text{ C}$

$A$ long rectangular conducting loop of width '$l$',mass '$m$',and resistance '$R$' is placed partly in a perpendicular magnetic field '$B$'. With what velocity should it be pushed downwards so that it may continue to fall without any acceleration? ($g = $ acceleration due to gravity)