$A$ body of mass $10 \, kg$ is attached to the end of a wire of length $0.3 \, m$. If the breaking stress of the wire is $4.8 \times 10^7 \, N/m^2$ and its cross-sectional area is $10^{-6} \, m^2$,what is the maximum angular velocity in $rad/sec$ with which it can be rotated in a horizontal plane without breaking the wire?

Why is the maximum height of a mountain about $\sim 10 \ km$ on Earth?

Two blocks of masses $1 \,kg$ and $2 \,kg$ are connected by a metal wire going over a smooth pulley. The breaking stress of metal is $\frac{40}{3 \pi} \times 10^6 \,N m^{-2}$. What should be the minimum radius of the wire used if it should not break (in $mm$)? $(g = 10 \,m s^{-2})$

$A$ rod of length $1.05 \; m$ having negligible mass is supported at its ends by two wires of steel (wire $A$) and aluminium (wire $B$) of equal lengths as shown in Figure. The cross-sectional areas of wires $A$ and $B$ are $1.0 \; mm^{2}$ and $2.0 \; mm^{2}$ respectively. At what point along the rod should a mass $m$ be suspended in order to produce $(a)$ equal stresses and $(b)$ equal strains in both steel and aluminium wires?

Copper has a face-centered cubic $(fcc)$ lattice with an interatomic spacing equal to $2.54 \ \mathring{A}$. The value of the lattice constant for this lattice is .... $\mathring{A}$ $[AIPMT \ 2005]$

$A$ steel wire is suspended vertically from a rigid support. When loaded with a weight in air,it extends by $l_a$ and when the weight is immersed completely in water,the extension is reduced to $l_w$. Then the relative density of the material of the weight is