A change of 0.8 ,mA in the anode current of a | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(A) The plate resistance $r_p$ is given by the ratio of change in anode potential to the change in anode current: $r_p = \frac{\Delta V_p}{\Delta i_p}

Vedclass · Accepted Answer

$6.25 \,V$

Vedclass · Answer

(A) The plate resistance $r_p$ is given by the ratio of change in anode potential to the change in anode current: $r_p = \frac{\Delta V_p}{\Delta i_p} = \frac{10 \,V}{0.8 	imes 10^{-3} \,A} = 12500 \, \Omega$.We know that the amplification factor $\mu = g_m 	imes r_p$,where $g_m$ is the transconductance.Also,$g_m = \frac{\Delta i_p}{\Delta V_g}$.Substituting $g_m$,we get $\mu = \frac{\Delta i_p}{\Delta V_g} 	imes r_p$.Rearranging for the change in grid voltage $\Delta V_g$: $\Delta V_g = \frac{\Delta i_p 	imes r_p}{\mu}$.Substituting the values: $\Delta V_g = \frac{4 	imes 10^{-3} \,A 	imes 12500 \, \Omega}{8} = \frac{50}{8} = 6.25 \,V$.

$A$ change of $0.8 \,mA$ in the anode current of a triode occurs when the anode potential is changed by $10 \,V$. If $\mu = 8$ for the triode,then what change in the grid voltage would be required to produce a change of $4 \,mA$ in the anode current?

Similar Questions

In a triode valve,the amplification factor is $20$ and the mutual conductance is $10^{-3} \text{ mho}$. The plate resistance is:

In a triode,${g_m} = 2 \times 10^{-3} \, \Omega^{-1}$,$\mu = 42$,and the resistance load $R_L = 50 \, \text{k}\Omega$. The voltage amplification obtained from this triode will be:

The mutual characteristic curves of a triode are as shown in the figure. The cut-off voltage for the triode is.....$V$.

$A$ triode has a plate resistance of $10 \, k\Omega$ and an amplification factor of $24$. If the input signal voltage is $0.4 \, V$ $(r.m.s.)$ and the load resistance is $10 \, k\Omega$,then the output voltage $(r.m.s.)$ is ...... $V$.

If ${R_p} = 7 \text{ k}\Omega$ and ${g_m} = 2.5 \text{ millimho}$, then on increasing the plate voltage by $50 \text{ V}$, how much must the grid voltage be changed so that the plate current remains the same? (in $V$)

Vedclass Test Series

Exam Paper Generator

Online Exam Module