$A$ small block of mass $0.1 \ kg$ lies on a fixed inclined plane $PQ$ which makes an angle $\theta$ with the horizontal. $A$ horizontal force of $1 \ N$ acts on the block through its center of mass as shown in the figure. The block remains stationary if (take $g = 10 \ m/s^2$):

What force should be applied on the wedge so that the block over it does not move? (All surfaces are smooth)

$A$ uniform cube of side $b$ and mass $M$ rests on a rough horizontal table. $A$ horizontal force $F$ is applied normal to one of the faces at a point at a height $3b/4$ above the base. What should be the coefficient of friction $\mu$ between the cube and the table so that it will tip about an edge before it starts slipping?

$A$ block of mass $2M$ is attached to a massless spring with spring-constant $k$. This block is connected to two other blocks of masses $M$ and $2M$ using two massless pulleys and strings. The accelerations of the blocks are $a_1, a_2$ and $a_3$ as shown in the figure. The system is released from rest with the spring in its unstretched state. The maximum extension of the spring is $x_0$. Which of the following option$(s)$ is/are correct? [$g$ is the acceleration due to gravity. Neglect friction]

$A$ disc of mass $100 \,g$ slides down from rest on an inclined plane of $30^{\circ}$ and comes to rest after travelling a distance of $1 \,m$ along the horizontal plane. If the coefficient of friction is $0.2$ for both inclined and horizontal planes, then the work done by the frictional force over the whole journey, approximately, is (Acceleration due to gravity, $g=10 \,ms^{-2}$) (in $\,J$)

$A$ man can move on a horizontal plank supported symmetrically as shown. The variation of normal reaction on support $A$ with distance $x$ of the man from the end of the plank is best represented by: