$A$ steel rod of length $1\,m$ and cross-sectional area $10^{-4}\,m^2$ is heated from $0^{\circ}C$ to $200^{\circ}C$ without being allowed to extend or bend. The compressive force produced in the rod is $........\times 10^4\,N$. (Given: Young's modulus of steel $Y = 2 \times 10^{11}\,N/m^2$,coefficient of linear expansion $\alpha = 10^{-5}\,K^{-1}$)

$A$ wire of cross-section $4 \; mm^2$ is stretched by $0.1 \; mm$ by a certain weight. How far (length) will a wire of the same material and length but of area $8 \; mm^2$ stretch under the action of the same force?

The dimensions of four wires of the same material are given below. In which wire will the increase in length be maximum when the same tension is applied?

$A$ metallic rod having area of cross-section $A$,Young's modulus $Y$,coefficient of linear expansion $\alpha$,and length $L$ is tied between two strong pillars. If the rod is heated through a temperature $t \, ^\circ C$,then how much force is produced in the rod?

Two rods of same material and volume having circular cross-section are subjected to tension $T$. Within the elastic limit,the same force is applied to both the rods. If the diameter of the first rod is half of the second rod,then the ratio of the extension of the first rod to the second rod will be: (in $: 1$)

In an experiment to determine the Young's modulus of a wire of length exactly $1\;m$,the extension in the length of the wire is measured as $0.4\;mm$ with an uncertainty of $\pm 0.02\;mm$ when a load of $1\;kg$ is applied. The diameter of the wire is measured as $0.4\;mm$ with an uncertainty of $\pm 0.01\;mm$. The error in the measurement of Young's modulus $(\Delta Y)$ is found to be $x \times 10^{10}\;N/m^2$. The value of $x$ is (Take $g = 10\;m/s^2$)