$A$ wire of length $L$ and radius $r$ is rigidly fixed at one end. On stretching the other end of the wire with a force $F$,the increase in its length is $l$. If another wire of same material but of length $2L$ and radius $2r$ is stretched with a force of $2F$,the increase in its length will be

If the given graph shows the load $(W)$ attached to and the elongation $(\Delta l)$ produced in a wire of length $1 \,m$ and area of cross-section $1 \,mm^2$, then the Young's modulus of the material of the wire is

One end of a steel wire of radius $r$ is fixed to a ceiling and a load of $3 \ kg$ is attached to the free end of the wire. Another wire made of copper of radius $2r$ is attached to the bottom of the $3 \ kg$ load and a $2 \ kg$ load is attached to the free end of the copper wire. The ratio of longitudinal strains produced in copper and steel wires is (Young modulus of steel $= 20 \times 10^{10} \ Nm^{-2}$,Young modulus of copper $= 12 \times 10^{10} \ Nm^{-2}$)

When the temperature of a wire of length $L_0$ is increased by $T$,what is the energy density? The volume expansion coefficient of the wire is $\gamma$ and the Young's modulus is $Y$.

$A$ $3 \ m$ long wire of radius $3 \ mm$ shows an extension of $0.1 \ mm$ when loaded vertically by a mass of $50 \ kg$ in an experiment to determine Young's modulus. The value of Young's modulus of the wire as per this experiment is $P \times 10^{11} \ Nm^{-2}$,where the value of $P$ is: (Take $g = 3 \pi \ m/s^2$)

$A$ copper wire of length $4.0 \, m$ and area of cross-section $1.2 \, cm^2$ is stretched with a force of $4.8 \times 10^3 \, N$. If Young's modulus for copper is $1.2 \times 10^{11} \, N/m^2$,the increase in the length of the wire will be: