If Young's modulus for a material is zero,then the state of material should be

When a uniform wire of radius $r$ is stretched by a $2 \, kg$ weight,the increase in its length is $2.00 \, mm$. If the radius of the wire is $r/2$ and other conditions remain the same,the increase in its length is .......... $mm$. (in $.00$)

In an experiment to determine the Young's modulus,steel wires of five different lengths $(1, 2, 3, 4$ and $5\,m)$ but of same cross-section $(2\,mm^2)$ were taken and curves between extension and load were obtained. The slope $(\text{extension/load})$ of the curves were plotted with the wire length and the following graph is obtained. If the Young's modulus of given steel wires is $x \times 10^{11}\,N/m^2$,then the value of $x$ is

If the ratio of diameters,lengths,and Young's modulus of steel and copper wires shown in the figure are $p, q$ and $s$ respectively,then the corresponding ratio of increase in their lengths would be

In an experiment,brass and steel wires of length $1\,m$ each with areas of cross-section $1\,mm^2$ are used. The wires are connected in series and one end of the combined wire is connected to a rigid support,while the other end is subjected to an elongation. The stress required to produce a total elongation of $0.2\,mm$ is: [Given: Young's Modulus for steel and brass are $120 \times 10^9\,N/m^2$ and $60 \times 10^9\,N/m^2$ respectively]

The speed of a transverse wave passing through a string of length $50 \; cm$ and mass $10 \; g$ is $60 \; ms^{-1}$. The area of cross-section of the wire is $2.0 \; mm^2$ and its Young's modulus is $1.2 \times 10^{11} \; Nm^{-2}$. The extension of the wire over its natural length due to its tension will be $x \times 10^{-5} \; m$. The value of $x$ is $...$