In a Vernier calipers, when both jaws touch each other, the zero of the Vernier scale is shifted to the right of the zero of the main scale and the $7^{th}$ Vernier division coincides with a main scale division. If the value of $1$ main scale division is $1 \text{ mm}$ and there are $10$ Vernier scale divisions, then the Vernier caliper has

The diameter of a spherical bob is measured using a vernier callipers. $9$ divisions of the main scale,in the vernier callipers,are equal to $10$ divisions of vernier scale. One main scale division is $1\, {mm}$. The main scale reading is $10\, {mm}$ and $8^{\text{th}}$ division of vernier scale was found to coincide exactly with one of the main scale division. If the given vernier callipers has positive zero error of $0.04\, {cm}$,then the radius of the bob is $...... \,\times 10^{-2} \,{cm}$.

If the screw on a screw gauge is given six rotations,it moves by $3\; mm$ on the main scale. If there are $50$ divisions on the circular scale,the least count of the screw gauge is:

Area of the cross-section of a wire is measured using a screw gauge. The pitch of the main scale is $0.5 \text{ mm}$. The circular scale has $100$ divisions and for one full rotation of the circular scale, the main scale shifts by two divisions. The measured readings are listed below.

Measurement condition	Main scale reading	Circular scale reading
Two arms of gauge touching each other without wire	$0$ division	$4$ division
Attempt-$1$: With wire	$4$ division	$20$ division
Attempt-$2$: With wire	$4$ division	$16$ division

What are the diameter and cross-sectional area of the wire measured using the screw gauge?

The vernier scale used for measurement has a positive zero error of $0.2\, mm$. If while taking a measurement it was noted that the '$0$' on the vernier scale lies between $8.5\, cm$ and $8.6\, cm$ and the vernier coincidence is $6$,then the correct value of measurement is ............. $cm$. (Least count $= 0.01\, cm$)

Which devices are used for the measurement of lengths of different orders?