In the block diagram of a simple rectifier ci | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(C) $1$. Diode Rectifier: This is the first stage,where the $A.C.$ voltage is rectified to produce a pulsating $D.C.$ voltage. The diode$(s)$ in the r

Vedclass · Accepted Answer

diode rectifier,filter,voltage regulator.

Vedclass · Answer

(C) $1$. Diode Rectifier: This is the first stage,where the $A.C.$ voltage is rectified to produce a pulsating $D.C.$ voltage. The diode$(s)$ in the rectifier allow current to flow only in one direction,converting the $A.C.$ input into a unidirectional current.$2$. Filter: After rectification,the output is a pulsating $D.C.$ that still contains ripples. $A$ filter (usually a capacitor or a combination of capacitors and inductors) smooths out these ripples,providing a more steady $D.C.$ output.$3$. Voltage Regulator: The final stage is the voltage regulator,which ensures that the $D.C.$ voltage remains constant,even if the input $A.C.$ voltage fluctuates or if there are variations in load. The regulator keeps the output voltage at a constant level by adjusting the current flow as needed.Therefore,the correct order of operation is:- Diode rectifier $\rightarrow$ Filter $\rightarrow$ Voltage regulator

In the block diagram of a simple rectifier circuit,from a variable $A.C.$ voltage,constant $D.C.$ voltage is obtained. The correct order of operation is

Similar Questions

$A$ sinusoidal voltage of peak value $200 \ V$ is connected to a diode and resistor $R$ in the circuit shown so that half-wave rectification occurs. If the forward resistance of the diode is negligible compared to $R$,the rms voltage (in volt) across $R$ is approximately:

In the diagram,the input is across the terminals $A$ and $C$ and the output is across the terminals $B$ and $D$,then the output is

Explain the use of a junction diode as a full-wave rectifier by drawing a circuit diagram and show the input and output waveforms.

The input a.c. voltage of frequency $60 \,Hz$ is applied to a half-wave rectifier and also to a full-wave rectifier. The output frequency in the case of the half-wave rectifier and that in the case of the full-wave rectifier is respectively:

For the circuit shown in the adjoining figure,to act as a full-wave rectifier,the $AC$ input should be connected across $....$ and $....$ and the $DC$ output would appear across $....$ and $....$.

Vedclass Test Series

Exam Paper Generator

Online Exam Module