Two flywheels are connected by a non-slipping belt as shown in the figure. $I_1 = 4 \ kg \ m^2$,$r_1 = 20 \ cm$,$I_2 = 20 \ kg \ m^2$,and $r_2 = 30 \ cm$. $A$ torque of $10 \ Nm$ is applied on the smaller wheel. Match the entries of column $I$ with appropriate entries of column $II$.

Quantities	Their numerical values (in $SI$ units)
a. Angular acceleration of smaller wheel	$1$. $5/3$
b. Torque on the larger wheel	$2$. $100/3$
c. Angular acceleration of larger wheel	$3$. $5/2$

$A$ particle of mass $M=0.2 \ kg$ is initially at rest in the $xy$-plane at a point $(x=-l, y=-h)$,where $l=10 \ m$ and $h=1 \ m$. The particle is accelerated at time $t=0$ with a constant acceleration $a=10 \ m/s^2$ along the positive $x$-direction. Its angular momentum and torque with respect to the origin,in $SI$ units,are represented by $\vec{L}$ and $\vec{\tau}$,respectively. $\hat{i}, \hat{j}$ and $\hat{k}$ are unit vectors along the positive $x, y$ and $z$-directions,respectively. If $\hat{k}=\hat{i} \times \hat{j}$,then which of the following statement$(s)$ is(are) correct?
$(A)$ The particle arrives at the point $(x=l, y=-h)$ at time $t=2 \ s$.
$(B)$ $\vec{\tau}=2 \hat{k}$ when the particle passes through the point $(x=l, y=-h)$.
$(C)$ $\vec{L}=4 \hat{k}$ when the particle passes through the point $(x=l, y=-h)$.
$(D)$ $\vec{\tau}=\hat{k}$ when the particle passes through the point $(x=0, y=-h)$.

$A$ cord of negligible mass is wound round the rim of a flywheel of mass $20 \; kg$ and radius $20 \; cm$. $A$ steady pull of $25 \; N$ is applied on the cord as shown in the figure. The flywheel is mounted on a horizontal axle with frictionless bearings.
$(a)$ Compute the angular acceleration of the wheel.
$(b)$ Find the work done by the pull,when $2 \; m$ of the cord is unwound.
$(c)$ Find also the kinetic energy of the wheel at this point. Assume that the wheel starts from rest.
$(d)$ Compare answers to parts $(b)$ and $(c)$.

Two masses of $0.3 \, kg$ and $0.7 \, kg$ are attached to the ends of a rod of length $1.4 \, m$ and negligible mass. The rod is rotated about an axis perpendicular to its length with a constant angular speed. The point on the rod through which the axis should pass so that the work required to rotate the rod is minimum is:

$A$ particle executes uniform circular motion with angular momentum $L$. Its rotational kinetic energy becomes half,when the angular frequency is doubled. Its new angular momentum is

$A$ ring of mass $M$ and radius $R$ sliding with a velocity $v_0$ suddenly enters a rough surface where the coefficient of friction is $\mu$,as shown in the figure. Choose the correct statement$(s)$.