$A$ thick brass wire of length $L$ and density $\rho$ is suspended from a rigid support. Due to its own weight,$\ell$ is the increase in length. The Young's modulus $Y$ of the brass wire in terms of density is $(g = \text{acceleration due to gravity})$

$A$ block of weight $100 \ N$ is suspended by copper and steel wires of same cross-sectional area $0.5 \ cm^2$ and lengths $\sqrt{3} \ m$ and $1 \ m$,respectively. Their other ends are fixed on a ceiling as shown in the figure. The angles subtended by the copper and steel wires with the ceiling are $30^{\circ}$ and $60^{\circ}$,respectively. If the elongation in the copper wire is $\Delta \ell_C$ and the elongation in the steel wire is $\Delta \ell_S$,then the ratio $\frac{\Delta \ell_C}{\Delta \ell_S}$ is. . . . . .
[Young's modulus for copper and steel are $1 \times 10^{11} \ N/m^2$ and $2 \times 10^{11} \ N/m^2$ respectively]

$A$ steel wire is $1 \,m$ long and $1 \,mm^2$ in area of cross-section. If it takes $200 \,N$ to stretch this wire by $1 \,mm$,how much force will be required to stretch a wire of the same material as well as diameter from its normal length of $10 \,m$ to a length of $1002 \,cm$?

Young's moduli of the material of wires $A$ and $B$ are in the ratio of $1: 4$,while their areas of cross-section are in the ratio of $1: 3$. If the same amount of load is applied to both the wires,the amount of elongation produced in the wires $A$ and $B$ will be in the ratio of [Assume length of wires $A$ and $B$ are same].

$A$ metal rod of length $L$ and cross-sectional area $A$ is heated through $T^{\circ} C$. What is the force required to prevent the expansion of the rod lengthwise? ($Y=$ Young's modulus of the material of the rod,$\alpha=$ coefficient of linear expansion of the rod.)

The following four wires are made of the same material. Which of these will have the largest extension when the same tension is applied?