The Young's modulus of a wire of length $L$ and radius $r$ is $Y \ N/m^2$. If the length and radius are reduced to $L/2$ and $r/2,$ then its Young's modulus will be

$A$ structural steel rod has a radius of $10 \;mm$ and a length of $1.0 \;m$. $A$ $100 \;kN$ force stretches it along its length. Calculate $(a)$ stress,$(b)$ elongation,and $(c)$ strain on the rod. Young's modulus of structural steel is $2.0 \times 10^{11} \;N \;m^{-2}$.

Two wires $A$ and $B$ of same length, same radius and same Young's modulus are heated to the same range of temperatures. If the coefficient of linear expansion of $A$ is $\frac{3}{2}$ times that of $B$, then the ratio of the thermal stresses produced in the two wires $A$ and $B$ is

Column $-II$ is related to Column $-I$. Join them appropriately:

Column $-I$	Column $-II$
$(a)$ When temperature is raised,Young's modulus of a body	$(i)$ Zero
$(b)$ Young's modulus for air	$(ii)$ Infinite
	$(iii)$ Decreases
	$(iv)$ Increases

$A$ metal rod is fixed rigidly at two ends so as to prevent its thermal expansion. If $L$, $\alpha$, and $Y$ denote the length of the rod, the coefficient of linear thermal expansion, and the Young's modulus of its material respectively, then for an increase in temperature of the rod by $\Delta T$, the longitudinal stress developed in the rod is

Two metallic wires $P$ and $Q$ have the same volume and are made up of the same material. If their areas of cross-section are in the ratio $4:1$ and a force $F_1$ is applied to $P$,an extension of $\Delta l$ is produced. The force required to produce the same extension in $Q$ is $F_2$. The value of $\frac{F_1}{F_2}$ is . . . . . . .